After many tests to figure out what would work out the best, we have chosen our best design. We will be using a 6mm diameter hole for the siphon, this will be sufficient for what we need it to do. I have been able to put together a model of the whole system to be able to visualize the prototype. Here is a rendering of the Super Validator configuration: 

Super Validator system

Super Validator system

This model only has the parts that will be 3D printed, the electronics will be sitting on the part that is attached to the pole. The electronics consist of a strain gauge connected to an ADC that will be sending data to an arduino.

Electronics setup

Electronics setup

The electronics have been calibrated and tested. We are currently printing both the validator and the pole attachement, and will soon have the first working prototype.